Proizvedeno u : Aziji

Programibilni tajmer za jednosmerne motore koji može da radi na dva načina.

U modu P-1 čeka signal na jednom od ulaza IN1 ili IN2 i kada ga dobije pokreće motor u određenom smeru zadati broj sekundi, isključuje se i čeka novi signal.

U modu P-2 ne čeka signal sa ulaza već odmah pokreće motor zadati broj sekundi, pravi pauzu koja se takođe definiše, pokreće motor u kontra smeru, pravi pauzu i tako u krug.

Za vreme pauza motor je u blokadi odnosno kratko spojeni su mu izvodi tako da ima i tu svojevrsnu kočnicu.

Relei izdržavaju po deklaraciji 20A ampera ali bih savetovao da se stave neka jača zbog trajnosti ili koriste sa manje od 10A.

Modovi se biraju dugim pritiskom na taster K1.

Karakteristike:
- Napajanje: 12 V DC
- Struja motora: 20 A max
- Podesivo vreme: 0-999 min
- Statička struja: 20 mA
- Radna struja: 50 mA
- Dimenzije: 85 x 45 x 27 mm
- Pamti zadate parametre po nestanku napajanja

A function: P-1:
To signal 1, the motor is transferred, after the delay time X, automatically stops.
2 to the signal, the motor reversal, after the delay time X, automatically stops.
Late in the period, again trigger can be set free:
A: Again trigger is invalid;
B: trigger again to re-timing;
C: once again trigger a reset timing, the motor stops immediately.
If the delay time is set to 0;
To signal 1, the motor is transferred, to maintain positive turn;
2 to the signal, the motor reversal, remain inverted.

Function two: P-2:
You do not need to signal the end, the power automatically reversing the motor;
Specific work: Stop Y (seconds, minutes)-Forward X (seconds, minutes)-Stop Y (seconds, minutes)- inverted X (seconds, minutes). . . cycle work. . . Cycle work.
If the stop delay time is set to 0;
Specific work forward X (seconds, minutes)-inverted X (seconds, minutes)-Forward X (seconds, minutes) - inverted X (seconds, minutes). . . cycle work.
Adjusting the delay time range: 0.1 seconds are 99.9 seconds, one second to 999 seconds, 1 minute to 999 minutes, customers can be adjusted.

The signal end: low trigger, you can access NPN sensors, proximity switches, keys, buttons, switches, etc.
The set parameters after power failure can never remember, input and output optocoupler isolation, enhanced anti-jamming capability power.
Line terminals are used KF7.62 terminals, screw terminal crimping large, easy wiring.
Points on both sides of the circuit board, the front main chip components, digital control and buttons. The back of the relay, terminal, electrolytic capacitors, this user-friendly installation panel.

Specifications:
Output capacity: DC 12V10A within Dual DC motor.
Working Voltage: DC 12V, need additional power supply voltage please contact customer service customization.
Static Current: 20mA
Working Current: 50mA
Color: green
Size: 85mm * 45mm * 27mm
Net weight: 43g