Proizvedeno u : Aziji

Multifinkcionalni modul koji moze da radi kao tajmer oican i ciklicni, zastita akumulatora. . .

This product is designed to meet the relevant national standards and electrical safety rules , with industrial-grade reliability, Selection of original authentic chips and components, Acer licensing power relays, military grade PCB, SMT chip technology, Is highly cost-effective , high-quality multifunction models relay control panel that allows you to control the lowest cost to meet a variety of needs.
Please follow the instructions wiring and operation ! This board is 12V power supply operating power range DC 10-15V, then 5.08mm connector terminals , as shown below .

The relay load contacts with three contacts ( a conversion ) : common point , normally closed , normally open , when the relay is not energized , the relay is released , the common point and normally closed switched on , when the relay coil is energized relay picks , common and normally open points will be connected .

Relay contact is equivalent to the switch, the wiring should be in series with the load power supply circuit , Power must not be short-circuited , contact a maximum load current of 10A.

Multiple modes for users to freely switch , a multifunction machine , premium application !

Mode display :

P-1: Time Relay (0.1 seconds to 99.9 seconds )

P-2: Time Relay ( 1 second to 999 seconds, 1 minute to 999 minutes )

P-3: Counting relay ( set value can count to start the relay, opto-isolated inputs )

P-4: Voltage Relay ( can be set lower limits on the voltage , overload relay )

P-5: switch timing trigger ( when the input level switch or timer to set the value of the trigger )

P-6: digital display automatically turns off the set ( minimum operating current 6mA / 12V)



Voltage detection and display range : Default DC 0-99.9V ( precision 0.1V) or DC 0-9.99V ( precision 0.01V), two hardware versions ;

If the power failure in either mode operation, the power again after the last state of the system will continue to run , parameter setting can be powered down to save , in either mode, press the ENTER key three seconds to return to the mode selected.



Electrical PropertiesParameters:

Working Power supply : DC10 ~ 15V
A set of conversion ( normally open normally closed )
Contact load : 10A / 277VAC 10A / 30V DC
Contact resistance : 100mΩ (1A-6VDC)
Mechanical Durability: > 10 million times
Electrical Durability: > 100,000 times (10A-250VAC)
Working temperature : -40℃ ~ 85℃
Standby Current: 16mA / 12V Minimum , the digital closed 6mA / 12V And relay timely 45mA / 12V
External signal input : voltage (5 ~ 12V); passive switch ( can be set to nine to shake delay time )
External signal or switch can trigger start relay
You can set the time T1 pull and release time T2, can also be a single execution cycle execution , set value can be powered down to save
Mode setting parameters can be powered down to save on electric mode execution continues after the last power failure
Digital control module uses the socket , the display can be turned off automatically.