Cena: |
Stanje: | Polovan bez oštećenja |
Garancija: | Ne |
Isporuka: | AKS Pošta Post Express Lično preuzimanje |
Plaćanje: | Tekući račun (pre slanja)
PostNet (pre slanja) Ostalo (pre slanja) Pouzećem Lično |
Grad: |
Niš-Palilula, Niš-Palilula |
Proizvođač: Dell
Dijagonala ekrana: Ostalo
The Wyse SX0 is a small and (physically) lightweight thin client. It has a single serial port and lacks any PS/2 ports. There are two USB ports at the front and two USB ports on the rear. It is available in a number of configurations which is reflected in the product ID : S10/S30/S50/S90.
From the marketing blurb:
S10 Featuring the blisteringly fast Wyse ThinOS designed for task-oriented environments.
S10: August 2008/November 2012.
Specifications
The basic specs for the SX0 are:
ProcessorType AMD Geode GX500
Speed 366MHz
Memory Flash
S10 0MB
S30 64MB
S50 64MB or 128MB
S90 512MB
RAM
S10 128MB
S30 128
S50 128/256
S90 256
Video Chip CS5535 1600 x 1200 16-bit colour
Ports
Network
USB
Serial
Parallel
PS/2 10/100
4 x USB2.0
Power
Input
Plug
Off
Running 12V 2.5A (from label)
Coax 5.5mm/2.1mm
0W
4-6W
Dimensions
W x H x D 17.5cm x 3cm x 12.5cm
(RAM: The RAM is provided by a standard 200-pin PC2700 SO-DIMM. (Bottom of the photo). I have successfully replaced the supplied 128MB module with a Hynix 256MB module and also a G-TEK 512MB module. The GX500 datasheet indicates that 512MB is the maximum size of memory supported.
The board includes a 44-pin IDE connector . I connected a 2.5` drive to this which had Tinycore 2.7 installed. With this in place the S10 booted and ran Tinycore Linux from the hard disk in preference to its internal operating system.)