Proizvedeno u : Aziji

Konvertor struje u napon

Neophodan elektronski sklop za transformaciju struje u napon i samim tim lakše baratanje istim.

Karakteristike:
- Napajanje: 7~36 V DC
- Ulazna signal struja: 0-20 ili 4-20 mA
- Izlazna signal napon: 0-3,3 ili 0~5 ili 0-10 V DC
- Podešavanje sa dva trimer potenciometra i 2 jumpera
- Dimenzije: 42 x 25 mm

1. The module is connected according to the definition, the supply voltage is 7-36V (if the output is to 10V, the supply voltage must be greater than 12V)

2. After power on, the D2 light should be bright, otherwise please check the line connection. Board with reverse connection protection, reverse connection not burning. 3. When the current input is minimum (0mA or 4mA), adjust the ZERO potentiometer, so that the output of VOUT is minimum (0.0V or other voltage) 4. When the current input is the maximum (20mA), adjust the SPAN potentiometer, so that the VOUT output is the maximum value (3.3V or 5V or 10V, when the input is 4-20mA, the minimum output can be 2.5V).

According to your needs, select the corresponding range by jumper cap: 4--20ma:0--2.5V range: J1 1, 2 feet short connection, 3, 4 feet short connection 0--3.3V range: J1 1, 2 feet off, 3, 4 feet off 0--5.0V range: J1 1, 2 feet short connection, 3, 4 feet short connection 0--10.0V range: J1 1, 2 feet short connection, 3, 4 feet off 0--20ma:0--3.3V range: J1 1, 2 feet short connection, 3, 4 feet short connection 0--5.0V range: J1 1, 2 feet short connection, 3, 4 feet short connection 0--10.0V range: J1 1, 2 feet short connection, 3, 4 feet off

Nakon povezivanja podesiti na trimer potenciometru struju na 4mA mereći između srednjeg zavrtnja i GND na desnome konektoru.

Postaviti onda ulazni napon na maksimalnu vrednost (3.3V; 5V; 10V ili 15V) i na drugi trimer potenciometar podesiti struju na 20mA.