Proizvedeno u : Aziji

Adapter za vezu ESP-01 modula i led dioda sa WS2812B u formi trake, plocice, prstena. . .
ESP-01 module kao i razne varijante sa WS2812B diodama mozete pronaci medju mojim oglasima.

This is a WS2812 RGB LED control module based on ESP-01 / 01S. With it, you can easily control the WS2812 light bar / light ring. DIY own lighting control system. Support Ard uino IDE programming.



characteristic:

* Master: ESP-01 / ESP-01S (This module does not include ESP-01 / ESP-01S)

* Control Pin: GPIO2

* Interface: 3Pin PH2.0 connector


* Operating Voltage: DC 3.7V-5V (Please note: The positive supply voltage VCC on the board is connected to the VCC on the WS2812 3PIN connector. Therefore, if your light bar / lamp ring is 5V powered, use DC 3.7V-5V power supply. )

* Support 3.7V lithium battery

Shipping list:

1. ESP-01S RGB LED module X1 (not include ESP-01S WiFi module and RGB LED)

2. 3PIN PH2.0 connector X1

Application example:

1. Power supply: 3.7V-5V DC power supply to the VCC GND (2.54mm pin)

2. Download the program to ESP-01S

3. Insert the ESP-01 / ESP-01S into the 2 * 4 Pin header (in the direction of the arrow) as shown below: